Heavy Duty Conveyor Belt Top & Back Filler (Long Rip Kit)

1 x 10m roll of 100mm Feather edge repair strip

1 x 20m roll of 35mm Feather edge repair strip 

2 x Pangofol glue kits 

1 x 3.8L Bufsol cleaner 

1 x Box of rubber crayons

1 x Wide hand roller

1 x Box of round glue brushes (12 of) 180mm Copper disk 36 grift (heavy duty belt buffer, advised to use variable speed grinder on low speeds)

This is the perfect kit for repairing holes and rips in your belt.

Start off cleaning the area with the cleaner, mark out the position the repair with the crayon, use the copper disk (variable speed grinder advised, to be buffed at low speed to avoid burning the belt) to rough up the rubber, again clean the area from debris and any potential contaminants, paint repair strip and belt area with the glue activated withe the hardener, wait for the first coat to dry completely, then use a light 2nd coat on the belt that dry to tacky, place the patch over the area and use the roller and make sure is its rolled down well and theres no trapped air. Leave repair to cure if possible over night or at least a few hours.

We hold lots of different sized patches and filler repairs and strips, so you can always replenish this kit with different consumables to keep your belt running.