Conveyor Belt Filler Strip Repair Kit.

1 x Pangofal glue and activator

1 x Bufsol Cleaner Aerosol

1 x Round brush for glue

1 x Scratch brush 

1 x Hand roller

1 x Box of rubber crayons 

1 x 10 metre Conveyor belt repair strip 100mm wide 

1 x Vulcafix repair resin 100g (comes with spreader and disposable gloves)

1 x Packout Milwaukee Bag 

This is the perfect kit for repairing damaged top and bottom fillers and rips in your belt. Start off cleaning the area with the cleaner, mark out the position of the strip with the crayon, use the scratch brush to rough up the rubber, again clean the area from debris and any potential contaminants, paint strip and belt area with the glue activated with the hardener, wait for the first coat to dry completely, then use a light 2nd coat on the belt let that dry to tacky, place the strip over the area and use the roller and make sure its rolled down well and there's no trapped air. Leave strip to cure if possible over night or at least a few hours.

We hold lots of different sized patches and filler repair strips, so you can always replenish this kit with different consumables to keep your belt running.